6-30V DC Motor speed Controller Reversible PWM Control
Forward / Reverse Switch
PWM motorvezérlő áramkör, gyárilag külső előre/hátra menet kapcsolóval, és külső potméterrel a kitöltés vezérléséhez.
Led-es tápjelző, és 2 led a kimeneti pwm-nek és irányoknak megfelelően.
Abs. max pillanatnyi 10A-es indítási terhelés, és maximum 6A-es folyamatos terhelésre.
Figyelem: Beépítésnél terhelés függően ügyelni kell a megfelelő hőelvezetésre és hűtésre.
Két változat, funkcióban egyformák, kétféle vezérlő jelgenerálással érkezik.
A változat: tápfeszültségről működő logikai rész is
B változat: a logikai rész 5V feszültségstabilizátorról működik, így az 5V-os potméter feszültségosztó helyére külső analóg 0-5V-os szignál is köthető.
Specification:
Material: Plastic, metal
High efficiency, high torque, low heat generating
Control the speed of a DC motor with this controller
With reverse polarity protection, high current protection
Input: DC 6~30V
Output: Max 80W
PWM range: 10% ~ 95%
Current: Max 10A (Recommend you to use in less than 6A)
With potentiometer
With reversible switch
Panel méret: 73.5mm * 45.5mm
Mounting hole center distance: 63.5 mm * 36.5 mm
Jellemzők:
The governor using PWM control technology, with high conversion efficiency, wide speed range, stable performance characteristics. Governor of all imported STMicroelectronics original chip, the factory and the voltage, current, function and many other detection circuit is stable and reliable.
Operating Instruction:
1. Connect it to the power, ensure the positive inversion switch located in the middle of the zero, and connected with a DC power supply(the DC supply voltage range is more than 6V and less than 30V). Warning: do not reverse the positive and negative terminals of DC power source, otherwise regulator may be damaged.
2. Connect it to the motor, the motor line can be positive or negative, when the running direction is not consistent with the expectative one, you can adjust the sequence of lines or switch position to change the direction.
3. Adjust the switch. Positive inversion switch is used to control the motor speed direction. When the switch is located on the zero position, the motor stops rotating.
4.Adjust the potentiometer knob. Adjusting potentiometer knob can change output duty ratio of the regulator, then motor speed change.
Bekötés jelölések:
+ és -: Táplálás (max 30V):
M1 és M2: motor pólusai